Complete footpeg bar for a C50 NT, C70 NT or C90 NT, suitable for the thick foot rubbers. The rubbers are not included in the set, order this if necessary, item number: 1040060115. This footpeg bar comes with 16cm side stand and therefore fits best on the Cub models, both OT and NT. Also great for: SS50, CD50, Dax, Monkey. For these models the side stand is a bit too short, but it fits and works fine! Note: in combination with some a down swept exhausts or different clutch crankcases, the footpegs bar will not fit. If in doubt, please contact us!

Complete footpeg bar with aluminum folding steps and 16 cm side stand (side stand). In terms of side stand length, this footpeg bar fits best on a C50 or C70, both OT and NT. Also great for: SS50, CD50, Dax, Monkey. With these models the side stand is on the short side, but it fits and works fine! Note: in combination with some down swept exhausts or different clutch crankcases, this footpegs bar does not fit. If in doubt, please contact us!

Complete footpeg bar with 16 cm side stand. In terms of side stand length, this footpeg bar fits best on a C50 or C70, both OT and NT. Also great for: SS50, CD50, Dax, Monkey. With these models the side stand is a bit short, but it fits and works fine! This footpeg bar is suitable for engines with a wide clutch crankcase such as Lifan 125 and 140cc. If you are unsure whether it fits, please contact us!

Complete footpeg bar with the narrow rubbers (we supply original Honda rubbers) and 16 cm side stand side stand. In terms of side stand length, this footpeg bar fits best on a C50 or C70, both OT and NT. Also great for: SS50, CD50, Dax, Monkey. With these models the side stand is a bit short, but it fits and works fine! Note: in combination with some down swept exhausts or different clutch crankcases, this footpegs bar does not fit. If in doubt, please contact us!

Complete footpeg bar with adjustable side stand from 16cm to 22cm. Because of the adjustable side stand, this footpeg bar is suitable for many models. You can set the desired length yourself and thus leave the moped on the stand at an angle or more straight. Suitable for: C50, C70, C90 not C90 SS50, CD50, Dax, Monkey. Note: in combination with some down swept exhausts or different clutch crankcases, the footpegs bar will not fit. If in doubt, please contact us.

Standard footpeg bar of a replica Monkey, with folding footpegs. This one is also the same as the replica Dax footpeg bar, but without a main stand. Also very useful when you have an engine with wide crankcases and your current footrests hit your engine! Tip: in this case mount the bar a little lower, for example by using M10 nuts as spacers. Also very suitable for an SS50, CD50 or Cub model, if you want the footpegs bar a lot lower than standard. Note: this does not work well with all types of exhausts! If in doubt, please contact us! With down and upswept exhausts such as NHRC, V8, Takegawa, Over etc. it is no problem!

Complete footpeg bar for a Skyteam PBR

Standard footpeg bar that fits Monkey. With folding footpegs and equipped with a main stand bracket!

Standard footpegs bar of a replica Dax. With folding footpegs and equipped with a main stand bracket! If the moped is standing on this stand, then the distance from the ground to the mounting points under the engine is 24 cm.

Nice reproduction complete footpeg bar, fits Monkey Z50a.

Footpeg bar bare, replacement. Suitable for SS50, CD50, C50, C70, C90 not C90 OT!, Dax, Monkey etc.